CUCAT Wiki | Main / Ite32

Back to the ITE nongraphical labs index

To complete this lab, you may copy and paste the questions to an editable file to answer them, or Download the lab in .doc format.

Please submit this lab to ite-instructors@ciscovision.org upon completion.

3.2 Lab: Install the Power Supply

Introduction

In this lab, you will install a power supply in a computer case.

Accessibility note: Use the same lab recording you used in lab 2.3.4 for module three labs up until 3.9.2. As with 2.3.4 you are welcome to use your own hardware for these labs.

Recommended Equipment

Power supply with a compatible form factor to the computer case
Computer case
Tool kit
Power supply screws

Step 1

Remove the screws from the side panels.

Remove the side panels from the computer case.

Step 2

Align the screw holes in the power supply with the screw holes in the case.

Secure the power supply to the case with the power supply screws.

Step 3

If the power supply has a voltage selection switch, set this switch to match the voltage in your area.

What is the voltage in your area?

How many screws secure the power supply in the case?

What is the total wattage of the power supply?

This lab is complete. Please have the instructor verify your work.